I installed and bolted down the wardrobe and upper cabinet to see how they interacted with the plywood liner. It all looks good and I took a break from that chore and set about cleaning up the upper bunk bed platforms. The plywood looked really manky, the paper had come off years ago and the glue residue had become stained and ugly. It was a real chore to remove the glue, I curse the engineer that specified glue that did not stick to the paper/vinyl coating but did did stick tenaciously to the plywood. I tried a few methods but the best was a sharp paint scraper followed by a random orbit sander (40 grit paper) then hand sanding with finer grit paper.
The big section that is bolted to the roof is really not visible when the sleeping pad is in place, but I still wanted it cleaned up and sealed with something. Again I turned to Sikkens Cetol 1. Following pics are self explanatory.
Both sides were finished. But I only some of the fold out section done. This section will be cut in half and additional hinges installed so it can be folded back over the rear section and clear the pop top. There is decreased headroom with the bed platform on top of the roof compared to the stock westy roof where the upper bunk rear section doubles as a ceiling. But more on that later when I get to it. The fold out section has a galvanized steel U-section edge on one end (held on by screws which also hold on snaps for the bunk pad), and a T-section vinyl moulding on the other end.
Unbelievably dirty eh?
And the scraping, one side…
Another one of those unsatisfying days, very little actually installed in the van, but I can almost see the end of the project.
#1 by Angus on August 2, 2011 - 8:17 am
You may feel progress is slow, but I’m impressed. Looking good! On the SOPWAATOW scale for this summer;
#2 by albell on August 2, 2011 - 8:45 am
Society Of People Who Actually Attempt To…?
I give up 🙂
#3 by Angus on August 2, 2011 - 8:50 am
Close…Society of People Who Actually Assemble Their Own Westy.
Your certificate should be in the mail shortly.
#4 by albell on August 2, 2011 - 8:57 am
Sheesh, I’m slow. Must be due to the brain stone I am trying to pass figuring out do-able solution to fairing the curved parts of the pop top hole.
#5 by Ed on August 2, 2011 - 11:39 am
I’ll second that, impressive!
I don’t think I would ever take on poptop-izing a vangon