Tools – prototype transmission wrench

Quentin asked me to make a wrench to fit a locking nut, in Syncro transmission. Fits the nut fine, not sure yet if it clears other components in the stack. Has to be tested. The centre of the 1/2” drive hole is 2.000 inches from the centre of the nut when engaged. So you can easily do the calc to adjust torque. It’s a simple thing, waterjet cut 1/4” steel plate.

  1. Leave a comment

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: